Building the Thunder Tiger Raptor 30 V2 Helicopter — Step Four

Step Four — Main Drive Gear Assembly

• This step is on page 7 of the Instruction Manual.

	The parts bag for this assembly.
	The one way clutch shaft comes inside the one way clutch housing.  Remove it.
	Place a drop of Loctite on each bolt and in the threads of the one way clutch housing.
	If you have a set of snap ring pliers this will be much easier.  I don't have a set and used a set of round needle nose pliers to spread the ring. If this ring comes off then your heli is doomed.  Be sure it is fully seated in the groove.
	Insert the one way clutch shaft through the gears.  Note which end is which.
	Another snap ring holds the shaft in place.
	With the snap ring in place, the Main Drive Gear is completely assembled.

Back to Thunder Tiger Raptor 30 V2
Airfield Models Home

Copyright © 2006 Paul K. Johnson